Alright, I'm sorry for the delays, had car issues and my laptop is in for repairs lol
Lets go,
Ok where we left off. Once you get all your walls pre fabbed, you can go ahead and fasten the enclosure via your brackets, screws, nails, lags, carriage bolts etc, whatever you fancy.
Then you can start on your ceiling, I built in the same fashion I did my bottom. Once you do that, drill some holes through the studs to run wires like so, staple them down too!
All you need is your two wires, white and black, drill out your plywood to drop the wires down before you close it too. Then same thing, insulate the top, bolt it together, grab a friend, and you should have this by now.
It's also smart to install some butt connectors for ease. It's even more importan to protect all your connections from moisture and humidity. I advocate shrink tubing religiously, more expensive then electrical tape, but worth it.
I kept my connection in my accessible joint.
Ok, now you have a partial box setup, now you can seal! Seal, seal, seal! Even though this is built with moving in mind, you can only do so much mobility wise. I took no chance for a leaky tank. I foamed every crack and void, and went through about 10 tubes of silicone so far.