Yes, the Herpstat-6 is pricey, but you get six SEPARATELY CONTROLABLE ports that DON'T ALL FAIL when one port goes down.
If any of the processor components fail, of course all the ports will fail--there aren't six separate 'single' processor systems in any proportional temp controller that I'm aware of...that would be rather expensive! And guess what, if your VE-100 processor fails you too will lose your "one" controlled port as well...you don't have a failover board in there either. And I mean, how often does that happen with these microprocessor boards? It's all hard coded firmware and no software, so that leaves few components to fail.
I recently lost one port on my "6", but it didn't knock out all six ports. My problem ended up being a bad probe, and since I am running two RH probes, I had two spares; and Dion, the owner of Spyder Robotics, is sending me a replacement. The spare probe is working flawlessly.
Finally, there are six separate fuses for each output...not just one; it would be nice if they were externally accessible, but they're not, you have to remove the cover. So, if you blow one output fuse you won't lose the other five outputs. I dont know where you heard that all the outputs fail if one fails, but that's not true.
Good luck with your Viv!
Quote:
Originally Posted by sattva
Thanks for the feedback guys... I wanted the Herpstat 6 but two things stopped me... One is it really doesn't fit into my budget right now... and two I read an article that if it fails you lose 6 devices not just one... I went ahead and ordered the Vivarium Electronics VE-100... Thanks again!
|