|
Re: Finally Arrived!
The silicone sealant goes around the inside edges and corners. I did lay down a fairly heavy bead before smoothing it out, and made certain it got pushed into any tiny gaps as I went along. A second round likely would be a good idea though, had to do that with the fiberglass tub/shower after the bathroom remodel. The seams in the surround were much wider, but even using a caulking gun to lay down the bead some water still managed to get through the first seal, but the 2nd application did the job. Bad thing is now the tops would have to be taken off again to do the 2nd coat, though that's just a matter of a couple minutes to remove the screws.
Will silicone bond to the first layer if it's already dry? I know that when resealing a glass aquarium you have to remove every scrap of the old silicone first and clean the glass with alcohol if you expect it to hold water w/out leaking when you're finished. With the tub surround I think the 2nd layer likely sealed separately from the first application since the seams go so deep.
__________________
7.6.26 Dominican red mountain boas, 1.1 carpet pythons, 3 ATB, 1.1 climacophora, 1.1 Russian rats, 1.1 prasina, 1.1 speckled kings, 3.3.1 corns, 1.1.1 black rats, 1.1 savu, 1.1 Stimson's, 1 spotted python, 1.1 Boiga nigriceps, 3 Olive house snakes, 1 Sonoran mountain king, 0.1 Sinoloan milk snake, 1.1 Dione rat snake.
|