border
sSNAKESs : Reptile Forum
 

Go Back   sSNAKESs : Reptile Forum > Enclosure Creation Forums > General Enclosure Discussion

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 03-15-16, 03:54 PM   #25
mike22ca
Member
 
Join Date: Dec-2015
Location: Sacramento, CA
Posts: 15
Country:
Re: Propper heating for Animal Plastics T25 and retic

My T25 finally arrived! It came on a giant pallet. I gave everything a good once over and signed off on the delivery. It came incredibly well packed, i was very impressed. Gave the directions a quick ready over once or twice and went at it. Everything went together extremely well and probably only took me like 30 mins by myself. I sealed the whole cage with the supplied goop and let that sit for a couple days to cure. Played with the heat panel for a bit (I had the biggest one RBI makes installed), works great. I plugged it straight in to power no thermostat just to see what kinda heat it would kick out. Does a pretty damn good job. I got the surface of it to about 200 maybe slightly over. You can still touch it although for not that long. Being that my cage is 18" high I was able to kick out 100+ degrees to the cage floor according to my temp gun. So after letting it sit for a few days and letting the floor goop cure up I finally got it ready for my snake. I researched the best placement of the probe and came across a couple different options people seemed to run. I went ahead and did the Thermostat hanging from the ceiling option. I already had a hole in the top that my power cable for the heat panel runs to so I just ran my prob through the same hole and taped it off on top (outside the cage) so it stays in the same area. Seems to work real well. I set my herpstat2 for 86 and in the warm are of the cage its about 90-92ish and the cooler side stays about 80. All in all Im pretty impressed with the setup! Its lots of room thats for sure. The only things I had issues with are 1. the center divide option - there are no screws or channels for it in the cage. Its purely a pressure fit wall. There should be additional support for the center divide if you're going to call it a center divide. 2, One of my swing down doors had a rivet that was put it half ***. However I called Ali up the next business day and let her know what was up and sent a few pics and she is sending me a replacement out asap. Def can't complain about the customer service!
mike22ca is offline  
Login to remove ads
 

Tags
animal plastics, cage, enclosure, retic, rhp

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 07:59 AM.

Powered by vBulletin®
©2000 - 2026, Jelsoft Enterprises Ltd.
Copyright © 2002-2026, Hobby Solutions.

right