|
Re: Thermostat probe location
Quote:
Originally Posted by bigsnakegirl785
Also, even the weight of the snake could throw the temps way off. I have the thermostat probes to my CHE and RHP inside my BCI's enclosure because that's really the only place to put them, and if he curls up against the probe, it goes from reading 90F to 74F. I then have to move the bugger off his probe and after a few minutes it reads the proper temps.
|
Don't put the stat probe at substrate level, particularly with a che. As you've already identified when the snake covers it then the stat thinks the temp has dropped and will increase power to the che. Che's kick out some serious heat and if your snake does this when you're not around to move it it could cause harm. I've measured my 150W at 80% power to be kicking out 350c + (662f!!  ). Your snake covers the probe and your che thinks it's needing to play catch up could cause significant issues.
Fix the probe to the back of the viv about 1/3 down the length and about 6-8" from the substrate. Keep the area either side and in front free of decor etc. This way the probe is in little danger of being covered.
Then use a thermometer with a probe at the hot spot or a temperature gun to set the stat level. It takes a bit of faffing around, my stat is set at c. 26c for hot spot temp of 32c for example and I monitor the hot spot with a thermometer price at the hot spot permanently and each day with a temperature gun also but the faffing is worth it as it is much safer.
Doing it this way also ensures the cool side never exceeds the temperature as per where the probe is so I am confident of a good thermal gradient. I know that the warm side is at least 26c, the hot spot 32c and the cool side not more than 26c 1/3 the way down the viv and cooler beyond that.
For completeness I have another probe at the cool end measuring temperature and humidity so I know my cool side during the day is 23c dropping to just below 21c at night.
UTH's are not really suitable for large snakes. They do not warm the whole snake - too much muscle mass and they generally just heat what is in contact with them and not the ambient air temp. This means the lower and outer 1/3 of say a boas muscle is heated and not the rest. This can cause digestive problems as well as localised overheating of the snake.
RHP's and CHE'S are much more suitable but with the probe etc setup as per the above. Never have the probe where the snake or decor etc could cover it.
__________________
0.1 B imperator, 1.0 M spilota harrisoni, 1.0 C hortulanus, 2.1 P reticulatus (Madu locality), 1.1 S amethystine, 1.1 L olivaceous, 1.0 C angulifer, 1.0 Z persicus, 0.1 P regius, 0.1 N natrix, 0.1 E climacophora, 1.0 P obsoletus, 0.1 L geluta nigrtia, 1.0 P catenifer sayi, 1.0 T lepidus
|